Cal OSHA 1599 (f)- CA MUTCD Approved
2 LOCATIONS TO SERVE YOU – SAN LEANDRO/STOCKTON
San Leandro Next Classes – 5/25, 6/1, 6/8
Stockton Next Classes – By Request
San Leandro Location: 15079 Wicks Blvd San Leandro, Ca
Stockton Location: 4686 E. Waterloo Rd Stockton, Ca
OSHA 1599 Flagger Training and Short Term Traffic Control Regulations are covered in a 4 hour class. This class meets Cal Trans, CA MUTCD, & Cal OSHA flagger training requirements.
All Students must demonstrate comprehension of Cal OSHA’s flagger regulations and techniques for flagging traffic safely.
Section 6E.01 Qualifications for Flaggers
Support: Whenever the acronym “TTC” is used in this Chapter, it refers to “temporary traffic control”.
Standard: A flagger shall be a person who provides TTC.
Because flaggers are responsible for public safety and make the greatest number of contacts with the public of all highway workers, they should be trained in safe traffic control practices and public contact techniques. Flaggers should be able to satisfactorily demonstrate the following abilities:
A. Ability to receive and communicate specific instructions clearly, firmly, and courteously;
B. Ability to move and maneuver quickly in order to avoid danger from errant vehicles;
C. Ability to control signaling devices (such as paddles and flags) in order to provide clear and positive guidance to drivers approaching a TTC zone in frequently changing situations;
D. Ability to understand and apply safe traffic control practices, sometimes in stressful or emergency situations; and
E. Ability to recognize dangerous traffic situations and warn workers in sufficient time to avoid injury.
Flaggers shall be trained in the proper fundamentals of flagging moving traffic before being assigned as flaggers. Signaling directions used by flaggers shall conform to Figure 6E-1. The training and instructions shall be based on this Manual and work site conditions and also include the following:
(1) flagger equipment which must be used,
(2) layout of the work zone and flagging station,
(3) methods to signal traffic to stop, proceed or slow down,
(4) methods of one-way traffic control,
(5) trainee demonstration of proper flagging methodology and operations,
(6) emergency vehicles traveling through the work zone,
(7) handling emergency situations,
(8) methods of dealing with hostile drivers,
(9) flagging procedures when a single flagger is used (when applicable),
Documentation of the training shall be maintained as required by Injury Illness and Prevention Program of the General Industry Safety Order in the California Code of Regulations (Title 8, Division 1, Chapter 4, Subchapter 7, Section 3203).
Flaggers shall be trained by persons with the qualifications and experience necessary to effectively instruct the employee in the proper fundamentals of flagging moving traffic.
Support: Refer to Construction Safety Order in the California Code of Regulations (Title 8, Division 1, Chapter 4, Subchapter 4, Article 11, Section 1599 – Flaggers) for flagger training. See Section 1A.11 for information regarding this publication.
Please Note: **CLASSES with less than 10 students may be rescheduled. All safety classes are payable in advance. Cancellation fees will apply unless 1 week written cancellation notice is given. Cancellation with less than 1 weeks written notice is non-refundable. Students will be placed in a future class if they cancel or “no show” with less than 1 week notice. Minimum class size requirements are subject to change without notice. NEED MORE INFORMATION or CLASS LOCATIONS? Call Joshua at 209-275-9564 or Steve at 510-364-6010 or firstname.lastname@example.org